Online Support.

 

Pre-1995 Opener Programming

You only have 20 seconds from the time the opener program button is actuated to send the security code.

Choose a 4-digit security code. Put the opener into the programming mode (described below**) Press the "enter" button followed by the selected 4-digit security code and then press and hold the "enter" button for 2 seconds. The opener will respond as described below.

**To put opener into programming mode, follow these instruction:

  1. To program a transmitter into an ACB equipped opener you will need to locate the programming buttons on the rear panel of the opener powerhead. You should see a small green LED and 3 small buttons labeled f+, f- and SC. You will
  2. Momentarily press the SC button once. The main light bulb will flash once.
  3. Follow the programming steps for your keypad listed above. The operator light bulb will flash twice, indicating the code was excepted.
  4. If your system is of the older type and does not have the smart button but rather has dipswitches located on the main circuit board, you will need to call (800) 562-8814 and ask for the correct matching code for your keypad or matching dipswitch changes.